Scientific Works

ISSN-print: 2073-8730
ISSN-online:
ISO: 26324:2012
Архiви

OPERATING CHARACTERISTICS OF ADSORPTIVE REGENERATOR OF LOW-POTENTIAL HEAT AND MOISTURE BASED ON COMPOSITE SORBENTS ‘SILICA GEL – SODIUM SULPHATE’ AND ‘SILICA GEL – SODIUM ACETATE’ SYNTHESIZED BY SOL – GEL METHOD

##plugins.themes.bootstrap3.article.main##

O. V. Kolomiyets
К. М. Sukhyy
E. A. Belyanovskaya
V. I. Tomilo
O. M. Prokopenko
M. P. Sukhyy

Анотація

The operating characteristics adsorptive regenerator of low-potential heat and moisture based on composite sorbents ‘silica gel – sodium sulphate’ and ‘silica gel – sodium acetate’ synthesized by sol – gel method are studied. Sorption heat regenerator operating and environmental test results are shown. Flows switch-over time is observed to depend on airflow rate and temperature differential between warm and cold ends of regenerator in steady-state conditions. Time dependences of absolute and relative humidity on the warm and cold regenerator ends are shown to be of periodic nature when both of sorbent used. Time dependences of temperature are observed to be periodic nature on warm and cold ends of regenerator and between holders with sorbent. Amplitude of time dependences of absolute and relative humidity and temperature for ‘silica gel – sodium acetate’ are stated to be less than observed when composite ‘silica gel – sodium sulphate’ used. Correspondence of temperature and humidity time dependences and sorbent sorption capacity is shown. Correlation between heat-regeneration-coefficient-dimensionless temperature differential and moisture-regeneration coefficients-dimensionless humidity differential dependences is approximated with fair accuracy for engineering calculation by linear polynomials of degree 2. Similarity of polynomials described both of dependences is shown to result from close interrelation between heat and mass transfer processes. These coefficients are shown to be capable of task-oriented variation in sufficient wide ranges by changing of half-cycle time, sorbent granules sizes and its amount. The investigation results can be used for development energy-efficient ventilation systems for residential and storage premises.
Ключові слова:
adsorptive heat and moisture regenerator, heat regeneration coefficient

##plugins.themes.bootstrap3.article.details##

Як цитувати
Kolomiyets, O., SukhyyК., Belyanovskaya, E., Tomilo, V., Prokopenko, O., & Sukhyy, M. (2017). OPERATING CHARACTERISTICS OF ADSORPTIVE REGENERATOR OF LOW-POTENTIAL HEAT AND MOISTURE BASED ON COMPOSITE SORBENTS ‘SILICA GEL – SODIUM SULPHATE’ AND ‘SILICA GEL – SODIUM ACETATE’ SYNTHESIZED BY SOL – GEL METHOD. Scientific Works, 80(1). https://doi.org/10.15673/swonaft.v80i1.233
Розділ
Статьи

Посилання

1. Elhelw M. (2016), Performance evaluation for solar liquid desiccant air dehumidification system Alexandria Eng. J., Available at: http://dx.doi.org/10.1016/j.aej.2016.02.021

2. Mehta J. R, Rane V. R. (2013), Liquid desiccant based solar air conditioning system with novel evacuated tube collector used as regenerator, Procedia Engineering, Vol. 51, pp. 688 – 693.

3. Aman J., Ting D.S.-K., Henshaw P. (2014), Residential solar air conditioning: Energy and exergy analyses of an ammonia – water absorption cooling system, App. Thermal Eng., Vol. 62, pp. 424–432.

4. Weber C., Berger M., Mehling F., Heinrich A., Nuněz T. (2014), Solar cooling with water – ammonia absorption chillers and concentrating solar collector. Operational experience, Int. J. of Refrigeration, Vol. 39, pp. 57 – 76.

5. Docenko, S. A., (2003), “Energy saving technologies of air ventilation and conditioning systems”, Strojprofil', no. 4, pp. 54 – 56.

6. Tyfour, W.R., Tashtoush, G., Al-Khayyat, A. (2015), Design and testing of a ready-to-use standalone hot air space heating system, Energy Procedia, Vol. 74, pp. 1228 – 1238.

7. Manyumbua, E., Martin, V., Fransson, T. (2014), Simple mathematical modeling and simulation to estimate solar-regeneration of a silica gel bed in a naturally ventilated vertical channel for Harare, Zimbabwe, Energy Procedia, Vol. 57, pp. 1733 – 1742.

8. Gordeeva, L.G. (2013), “Composite materials “salt in porous matrix”: design of adsorbents with defined proper-ties”, D. Sc. Thesis, Federal state science establishment G.K. Boreskov Institute of catalysis Syberian department AS ofRussia, Novosibirsk, Russia.

9. Aristov, YU.I., Mezencev, I.V., Muhin, V.A. (2006), “New approach to regeneration of heat and moisture in indoors ventilation system. II. Real device prototype”, Inzhenerno-fizicheskij zhurnal, Vol. 79, no. 3, pp. 1 – 7.

10. Sukhyy K.M., Belyanovskaya E.A., Kozlov Ya.N., Kolomiyets E.V., Sukhyy M.P. (2014), Structure and Adsorp-tion Properties of the Composites ‘Silica Gel – Sodium Sulphate’, obtained by Sol – Gel Method, Applied Thermal Engineering, Vol. 64, pp. 408 – 412.